All-Bond 2

a 2-component primer system; primer A contains 2% sodium salt of N-p-tolylglycineglycidyl methacrylate

Networked: 5 relevant articles (0 outcomes, 0 trials/studies)

1.	Ferrari, Marco: 2 articles (06/2008 - 11/2002)
2.	García-Godoy, Franklin: 1 article (10/2011)
3.	Nakabayashi, Nobuo: 1 article (10/2011)
4.	Piemjai, Morakot: 1 article (10/2011)
5.	Waleepitackdej, Onusa: 1 article (10/2011)
6.	Breschi, Lorenzo: 1 article (06/2008)
7.	Cagidiaco, Maria Crysanti: 1 article (06/2008)
8.	Coniglio, Ivanovic: 1 article (06/2008)
9.	Gallina, Giuseppe: 1 article (06/2008)
10.	Magni, Elisa: 1 article (06/2008)

1.	Smear Layer 01/01/2000 - "All-Bond 2 did not etch beyond the smear layer. " 12/01/1994 - "For All-Bond 2, unetched, the smear layer was not removed before the primer and the adhesive were applied. " 10/01/2011 - "However, leakage was observed at dentin margins in two wet with primer systems, All-Bond 2 (1.31 +/- 1.39 mm) and Single-Bond 2 (0.37 +/- 0.28 mm), which required phosphoric etching to remove a weak smear layer on prepared dentin."
2.	Blister (Bulla) 06/01/2008 - "Specimens bonded with Pre-Bond unfilled resin of All Bond 2 without primer application showed no blister formation. "
3.	AIDS-Related Complex (ARC) 11/01/2002 - "Group 1: All Bond 2 with C & B (Bisco); Group 2: Scotchbond Multipurpose Plus with Opal Luting Composite (3M); Group 3: Scotchbond 1 in combination with Rely X ARC resin cement (3M); Group 4: One-step with C & B resin cement (Bisco); Group 5: All Bond Experimental with Post Cement HI-X (Bisco). "