Valorisation of electric arc furnace steel slag as raw material for low energy belite cements.
|
| Abstract |
In this paper, the valorisation of electric arc furnace steel slag (EAFS) in the production of low energy belite cements is studied. Three types of clinkers were prepared with 0 wt.% (BC), 5 wt.% (BC5) and 10 wt.% (BC10) EAFS, respectively. The design of the raw mixes was based on the compositional indices lime saturation factor (LSF), alumina ratio (AR) and silica ratio (SR). The clinkering temperature was studied for the range 1280-1400°C; firing was performed at 1380°C based on the results regarding free lime and the evolution of microstructure. In order to activate the belite, clinkers were cooled fast by blown air and concurrent crushing. The results demonstrate that the microstructure of the produced clinkers is dominated by belite and alite crystals, with tricalcium aluminate and tetracalcium-alumino-ferrite present as micro-crystalline interstitial phases. The prepared cements presented low early strength development as expected for belite-rich compositions; however the 28-day results were 47.5 MPa, 46.6 MPa and 42.8 MPa for BC, BC5 and BC10, respectively. These values are comparable with OPC CEMI 32.5 N (32.5-52.5 MPa) according to EN 197-1. A fast setting behaviour was also observed, particularly in the case of BC10, whereas soundness did not exceed 1mm.
|
|---|---|
| Authors | R I Iacobescu, D Koumpouri, Y Pontikes, R Saban, G N Angelopoulos |
| Journal | Journal of hazardous materials (J Hazard Mater) Vol. 196 Pg. 287-94 (Nov 30 2011) ISSN: 1873-3336 [Electronic] Netherlands |
| PMID | 21944704 (Publication Type: Journal Article, Research Support, Non-U.S. Gov't) |
| Copyright | Copyright © 2011 Elsevier B.V. All rights reserved. |
| Chemical References |
|
| Topics |
|
Join CureHunter, for free Research Interface BASIC access!
Realize the full power of the drug-disease research graph!