|1.||Itthagarun, Anut: 1 article (12/2004)|
|2.||Pashley, David H: 1 article (12/2004)|
|3.||Wei, Stephen H Y: 1 article (12/2004)|
|4.||Tay, Franklin R: 1 article (12/2004)|
|5.||Wefel, James S: 1 article (12/2004)|
|6.||García-Godoy, Franklin: 1 article (12/2004)|
|7.||Giannini, Marcelo: 1 article (01/2002)|
|8.||Ambrosano, Glaúcia M Bovi: 1 article (01/2002)|
|9.||Chaves, Patricia: 1 article (01/2002)|
12/01/2004 - "Fluid conductance after bonding with the single-step adhesives Prompt L-Pop and Etch&Prime 3.0 were not significantly different from those recorded from smear layer-covered dentin. "
01/01/2002 - "Flat dentin surfaces were abraded wet with 600-grit SiC paper and randomly assigned to 12 groups, according to three adhesive systems--Prime & Bond NT (PB), Clearfil Mega Bond (CMB) and Etch & Prime 3.0 (EP)--and four dentin surface treatments: direct application over smear layer (no treatment), sandblasting with 50 microm Al2O3 for 10 s, etching with 36% phosphoric acid for 15 s, or conditioning with 0.5 M EDTA for 2 min. Composite "crowns" (6.0 mm high) were incrementally built on the bonded surfaces and teeth were stored in distilled water at 37 degrees C. "
|1.||Edetic Acid (EDTA)
|2.||Prime and Bond NT
|4.||phosphoric acid (orthophosphoric acid)
|1.||Crowns (Crown, Dental)